Alarm Response: What Happens in the Fifteen Minutes After a Trigger

May 27, 2026

An alarm panel does one thing: it sends a signal. Everything that turns that signal into a person standing in front of your door, deciding whether to call the police or reset the system, happens somewhere else. Here is the sequence, minute by minute, and where it commonly breaks down.

Minute zero: the signal leaves the building

A sensor trips, a glass-break detector hears the right frequency, or a door contact opens outside of schedule. The control panel waits out the entry delay, usually 30 to 60 seconds, to give a legitimate user time to disarm. If nobody does, the panel transmits an event code to a monitoring station over the internet, cellular or a landline. That transmission is the first place things go wrong: panels on a single internet line lose contact during a power cut, and older cellular communicators on retired network standards simply stop talking. Any site in Ottawa that has not had its communicator checked in the last two years should.

Minutes one to three: verification at the monitoring station

The monitoring station is a staffed room, often outside Ottawa, that receives thousands of signals a night. An operator sees your event with your site file: address, keyholders, call order, verification rules. The operator’s job is to decide whether this is real. Verification usually takes one of three forms:

  • Call verification — the operator phones the premises and then the first keyholder. A password cancels the alarm; no answer or a wrong password escalates it.
  • Video verification — cameras tied to the alarm push a short clip to the operator, who can see a raccoon, a cleaner or an intruder. This is increasingly required before police will be dispatched at all.
  • Multiple-zone logic — two sensors tripping in sequence, such as a door then an interior motion, count as confirmed activity.

Ottawa, like most Ontario municipalities, treats unverified alarms as low priority and charges fees for repeat false alarms. Verification is what buys a real police response.

Minutes three to five: the dispatch decision

Once the operator decides the alarm is worth acting on, the site file says what to do. For a monitored-only account the answer is to call the keyholder list and, if the rules allow, the police. For an account with a response contract, the operator dispatches a licensed guard from the response provider. That call goes to a dispatcher or directly to a patrol vehicle, and the clock that matters to you starts here: the provider’s response-time commitment is measured from dispatch, not from the original trigger.

This is the number to ask about when comparing providers. A commitment of 20 to 30 minutes within the Greenbelt is common; suburbs such as Orleans, Barrhaven and Kanata often carry 30 to 45 minutes overnight, and rural edges of the city longer. A provider quoting ten minutes for the whole city is describing an ideal, not a schedule.

Minutes five to fifteen: the guard on the road and on site

The responding guard is normally already out on a mobile patrol route, which is why alarm response is almost always sold alongside patrol. The guard drives to the site with the alarm details on a phone or tablet: which zone, which door, whether the keyholder has been reached, and whether police are already en route.

On arrival the guard does not enter first. The order of operations is a perimeter check for signs of forced entry, a look through windows, then a decision. If there is evidence of a break-in, the guard holds position, calls the monitoring station to request police, and waits. Entering a building with a possible intruder inside is not what an unarmed guard is licensed or trained to do. If the perimeter is intact and the cause is obvious, a balloon in front of a motion sensor or a door left ajar by staff, the guard secures the door, resets or silences the panel with the code on file, and files a report.

What happens after: the report and the keyholder

Every response ends with a written report: time of dispatch, time of arrival, findings, actions, photos, and who was notified. A good provider sends it before the business opens in the morning. The keyholder is called with a summary either way, because the point of a keyholder is not to drive across town at 3 a.m.; it is to make the decisions a guard cannot, such as authorising a locksmith or a board-up.

Guard keyholding, where the provider holds your keys in a sealed and logged system, exists precisely so that nobody on staff has to attend. It is a modest add-on and it removes the most common failure of the whole chain: a keyholder who does not answer the phone.

What the service costs in Ottawa

  • Monitoring only — roughly $25 to $60 per month for a commercial account, more for video verification.
  • Guard response on retainer — often $40 to $120 per month to be on a provider’s response list, sometimes waived for patrol clients.
  • Per dispatch — usually $50 to $90 for the first hour, then an hourly rate if the guard must stay to secure the site.
  • Keyholding — commonly $15 to $40 per month.
  • Municipal false-alarm fees — after a free allowance, fees in the low hundreds per event are typical and rise with repeats.

A checklist before you sign a response contract

  • Response time in writing, measured from dispatch, with a separate figure for your part of the city.
  • Who is actually responding — the provider’s own licensed guards or a subcontractor, and how many vehicles are on the road overnight.
  • Verification rules agreed with the monitoring station so that guards are not sent to every balloon.
  • Keys and codes — how they are stored, logged and changed when a guard leaves the company.
  • Report format and delivery time, with photos.
  • Authority limits — what the guard may do without calling you: reset, board up, call a locksmith, stay on site.

Common mistakes

Assuming the alarm company sends someone. Most monitoring contracts only make phone calls. Guard response is a separate line and a separate provider unless you have arranged otherwise.

A stale call list. Keyholders leave the company, change numbers and go on vacation. Review the list every quarter.

Zones that trigger every windy night. Every false dispatch costs a fee and erodes the response you get when it counts. Fix the sensor.

No panel code on file. A guard who cannot silence the alarm cannot secure the site and leaves it screaming until the keyholder arrives.

Fifteen minutes is a system, not a promise

The interval between a trigger and a person on site is the sum of a communicator that transmits, a station that verifies quickly, a dispatch rule that is not too cautious, a vehicle that is close enough, and a guard who knows what to do on the doorstep. Any one of those links can be slow, and the weakest one sets your real response time. Test the chain once a year by triggering a scheduled alarm and timing every step.