Risk Assessment Examples for Ottawa Businesses: A Practical Walkthrough

November 5, 2026

A risk assessment is easier to understand when you watch it applied to a real kind of place. The same method gives very different results for a downtown office tower than for a neighbourhood shop, because the people, the hours and the threats are different. This guide explains why the method works the way it does, then walks through four typical Ottawa settings.

  • A risk assessment follows a repeatable sequence, but the output depends on who uses the site, when, and what could go wrong there.
  • Scoring can be descriptive (a matrix) or numeric, and the choice should match the decisions you need to make.
  • An assessment is a living record: it should be reviewed after an incident or a change in how the site is used.

What does a risk assessment actually do?

Before looking at examples, it helps to know what the exercise is for. A risk assessment is a process for identifying hazards, working out how likely they are to occur, and deciding which actions could reduce their effects. It is not a one-off form to file away. It is the first stage of a broader approach to managing risk, and its value comes from the decisions it supports.

The reason the process is structured is consistency. If every part of a business is judged against the same sequence, the results can be compared, and the money you spend goes to the problems that matter most rather than the ones that feel most alarming. A structured tool also makes your reasoning visible to managers, insurers and staff, who can see why a given control exists.

The process is usually described in five steps:

  1. Identify the hazards.
  2. Evaluate the risk each one represents.
  3. Put control measures in place.
  4. Document the findings.
  5. Review the assessment and change it where needed.

Each of the four examples below follows this sequence. What changes is the content of each step.

How do you set the scope before you start scoring?

Most weak assessments fail at the start, not the end. If the scope is vague, the findings are vague. Decide exactly what you are assessing: a single floor, an entrance, a process such as closing the till at night, or a whole building. A narrower scope produces conclusions you can act on.

Then decide who takes part. Supervisors, managers and the people who actually work in the space all notice different things. A cleaner who locks up at night often knows more about unlocked doors than anyone in the head office. Include them, and the assessment will reflect how the place really operates rather than how the floor plan suggests it should.

Finally, note what rules and policies apply to the site. Compliance requirements shape what you must do, while the assessment shapes what else is sensible. Keeping the two separate in your notes avoids the common mistake of treating the legal minimum as the full answer.

Gather the context early: opening hours, headcount at different times of day, who has keys or fobs, what is stored on site, and what has gone wrong before. These facts feed every step that follows.

What do the four Ottawa examples look like in practice?

The four settings below are illustrations of how reasoning changes with context. They are not findings about any real building, and the likelihood and severity you assign should come from your own site and from current local crime statistics.

A downtown office tower

Occupancy is high on weekdays and low at night, so the main concerns are unauthorised access, tailgating through controlled doors, and the effect of an evacuation on hundreds of people at once. The tower may have a lobby presence and access control already, so the assessment records those as existing controls and asks whether they cover the quiet hours as well as the busy ones.

A Glebe retail unit

A small shop faces a different mix: theft during opening hours, a cash-handling routine at close, and a staff member who is sometimes alone. The severity of a single incident may be modest, but the likelihood can be higher, and the human factor of lone working carries more weight than in a large building.

A Kanata technology campus

Here the valuable things are often equipment, data and people with specialised access. Perimeter control, visitor management and the protection of server areas matter more than shoplifting. Hours may be irregular, with staff arriving early or leaving late, so access rules need to fit real working patterns.

A ByWard Market event venue

Crowds, alcohol and late hours change the picture again. The assessment looks at capacity, entry and exit flow, and what happens when a night ends and a large group leaves at the same time. Because use of the venue changes from event to event, the assessment needs to be revisited for each type of booking.

Notice that the same five steps produced four different priorities. That is the point of the exercise: the method stays fixed while the inputs change.

How do you identify threats and judge how likely they are?

Threat identification works best as a walk through the site with a short list of categories in hand. For the settings above, a sensible list includes theft, unauthorised access, workplace violence and fire. Add anything specific to your operation, such as cash on hand or valuable stock. Write each hazard as a plain description of what could happen and to whom, not as a label.

Likelihood is where outside information helps. Use them as context rather than as a prediction for your own door, because a citywide or neighbourhood figure says little about a particular building with its own lighting, layout and staffing.

Combine that outside picture with what you know from inside the business: past incidents, near misses, and what staff tell you. A near miss is useful evidence even when nothing was lost, because it shows a weakness that has not yet cost you anything.

Be careful about two habits. The first is assuming that a risk is rare because it has not happened to you. The second is overweighting a dramatic event that is statistically unusual. Some risks behave predictably and some do not, and a few rare events can matter far more than many small ones. Recording the uncertainty in your estimate, rather than hiding it behind a confident number, makes the assessment more honest and more useful.

Matrix or numbers: which scoring approach fits?

Results can be expressed qualitatively or quantitatively, and both are legitimate. The right choice depends on the decision in front of you.

A qualitative matrix plots each risk by likelihood and by severity, then assigns a rating such as low, medium, high or extreme. Its strength is speed and clarity. A colour-coded grid lets a group see at a glance which risks deserve attention, and it supports a productive conversation among people who are not specialists. For most small and mid-sized Ottawa businesses, this is a reasonable place to start.

A quantitative approach attaches numbers to the loss and to its probability, and multiplies them to compare risks. It suits situations where you need to weigh the cost of a control against the loss it would prevent, such as a large capital purchase. Its weakness is false precision: if the inputs are guesses, the output only looks exact.

Whichever you choose, keep the scale consistent across the whole assessment, define what each rating means in plain words, and write down the assumptions behind the scores. A risk can also be judged tolerable when the cost or difficulty of a control outweighs the expected loss. Recording that decision, and the reasoning for it, is part of a good assessment rather than a gap in it.

Once risks are rated, list the controls already in place, then decide what further action is proportionate. Proportion is the key word: the aim is to reduce the highest risks first, not to eliminate every possibility.

When is a written assessment required, and when should you update it?

The sources reviewed for this article do not set out the precise Ontario obligations, so the exact triggers are not described here. Check the requirements that apply to your workplace with the Ministry of Labour or a qualified health and safety professional, and treat a written record as good practice even where it is not strictly demanded.

Keeping the assessment current matters as much as writing it. A risk assessment includes periodic review, with updates when necessary. Three situations should prompt that review:

  • After an incident or near miss, even a minor one.
  • When the way the site is used changes, such as new tenants, longer hours, a new entrance, or a different kind of event.
  • When existing controls change, for example if a door is replaced or a staffing pattern shifts.

Treat the document as a working record. Note the date of each review, what changed and who agreed to it. If an incident does occur, the assessment helps you see whether the hazard was already identified, whether the controls were in place, and what should be adjusted.

The practical test is simple. If someone new read your assessment today, would it describe the site as it really operates? If not, it is out of date, and the controls it recommends may no longer match the risks you face.

Related reading

Sources

Photo: Ottawa downtown winter, by Owen Byrne, CC BY 2.0 (Wikimedia, via Openverse)